# 进入系统视图。
system-view
[H3C] user-interface aux 0
[H3C-ui-aux0] authentication-mode password
[H3C-ui-aux0] set authentication password cipher 123456
[H3C-ui-aux0] user privilege level 2
3、配置Telnet
system-view
[H3C] user-interface vty 0 4
[H3C-ui-vty0] authentication-mode password
[H3C-ui-vty0] set authentication password cipher 123456
[H3C-ui-vty0] user privilege level 3
[H3C-ui-vty0] protocol inbound telnet
4、配置交换机VLAN 1 管理地址
system-view
[H3C] interface vlan-interface 1
[H3C-VLAN-interface1] ip address 192.168.0.129 255.255.255.0
5、配置交换机网关地址
[H3C]ip route-static 0.0.0.0 0.0.0.0 192.168.0.1
6、配置HTTP服务
[H3C] local-user admin #创建http用户
[H3C-luser-admin] service-type telnet
[H3C-luser-admin] authorization-attribute level 3
[H3C-luser-admin] password cipher admin #设置http用户密码,并加密显示
7、配置SNMP
[H3C]snmp-agent
[H3C]snmp-agent community read 123456 #设置snmp团体名称 ，权限为只读
[H3C]snmp-agent sys-info version v1 v2c #设置snmp版本v1 和v2
8、Qos端口限速
[H3C] interface gigabitethernet 1/0/1
[H3C-GigabitEthernet1/0/1] qos lr inbound cir 5120
[H3C-GigabitEthernet1/0/1] qos lr outbound cir 5120
9、创建VLAN
[H3C] vlan 100
10、删除VLAN
[H3C] undo vlan 100
11、将端口加入vlan 100
[H3C] interface GigabitEthernet 1/0/24
[H3C] port access vlan 100
12、查看VLAN
[H3C]display vlan all
12、查看端口状态
[H3C]display interface GigabitEthernet 1/0/24
14、启用端口
[H3C]interface GigabitEthernet 1/0/24
[H3C]undo shutdown
15、关闭端口
[H3C]interface GigabitEthernet 1/0/24
[H3C]shutdown
16、查看MAC地址列表
[H3C]display mac-address
17、查看arp信息
[H3C]display arp
18、查看current配置
[H3C]display current-configuration
19、查看saved配置
[H3C]display saved-configuration
注:current 配置是保存在交换机内存里面，当交换机重启时，不会生效
要交换机重启时生效，必须保存在saved-configureation配置里
20、保存交换机配置
[H3C]save
